#CISCO 2960 SWITCH SETUP HOW TO#

Telnet access password for the Cisco 2960 switch How to Configure POE in Cisco.

Privileged Exec mode password for the Cisco 2960 switch 3. Cisco 2960 switch with telnet access enabled 2. See How to configure Port Mirroring in different call scenarios. Among all Cisco Catalyst 2960 switches, WS-C2960-24TT-L and WS-C2960-24TC-L are best selling models. PoE lowers the total cost of network installation and maintenance and is easy to enable on a Cisco 2960 switch in a few minutes. That assumes you have 5 IP Phones and they are connected to ports 6, 7, 8, 9 and 10 on the switch and MiaRec server is connected to port 3. You will need to execute command in point 2 (see above example) multile times for every port: C2960# configure terminalД¬2960(config)# monitor session 1 source interface fastethernet 0/6Д¬2960(config)# monitor session 1 source interface fastethernet 0/7Д¬2960(config)# monitor session 1 source interface fastethernet 0/8Д¬2960(config)# monitor session 1 source interface fastethernet 0/9Д¬2960(config)# monitor session 1 source interface fastethernet 0/10Д¬2960(config)# monitor session 1 destination interface fastethernet 0/3 For additional installation and configuration information for Catalyst 2960 switches, see the. Should you have any questions or issues, please, do not hesitate to contact our support team.Д¬aution! If you have inter-office calls (between local phones), then every phone's port should be set as a Source Port (Cisco Catalys 2960 switches supports monitoring of multiple ports). Now a configuration is completed and you should be able to record calls with MiaRec Business. Check, if everything is configured correctly: C2960# show monitor session 1 C2960(config)# monitor session 1 destination interface fastethernet 0/3Д¤. Configure interface Fast Ethernet 0/3 as destination port for session 1. Create monitoring session and configure interface Fast Ethernet 0/5 as source port for that session: C2960(config)# monitor session 1 source interface fastethernet 0/5ДЈ. Enter configuration mode: C2960# configure terminalДў. In this case you need to execute following command on the switch:ДЎ. On the network diagram it is shown in green color (Monitored port). On the network diagram it is shown in a red color (Analysis port).ДЄnd port 5 is used for connecting to IP-PBX (if you have one) or uplink to WAN/Internet (if you do not have IP-PBX). Lets assume MiaRec Server is connected to port 3. Configure Port Mirroring function on the switch.

#CISCO 2960 SWITCH SETUP SERIES#

MiaRec also should be connected to Cisco Catalyst 2960 Series switch. All IP Phones, for which a call recording is necessary, should be connected to Cisco Catalyst 2960 Series switch.

Cisco 2960 switch setup